Chainsaw Poulan Wild Thing 18 Manual

Posted on
Chainsaw Poulan Wild Thing 18 Manual Average ratng: 4,8/5 1700 reviews

Poulan Wild Thing Chain Saw The Wild Thing Chainsaw by Poulan is designed for light duty work around the home or farm. The stock Poulan Wild Thing has an 18 in. Steel bar, and a powerful 40 cc. 2-cycle gas chain saw (.as rated by manufacturer). Other benefits are an automatic chain oiler and a primer bulb for easy starting. The super clean air filter system keeps dust and debris from the job from contaminiating the engine.

The Wild Thing also includes carrying case and is protected by a 1 year limited consumer warranty. The Wild Thing is considered to be a well balanced saw for small to medium sized jobs. It is inexpensive and can be used for light trimming and smaller jobs. Finding Parts for the Wild Thing are generally inexpensive, but if you have to have major repair work done the expense of the bench time can far outweigh the cost of the parts(as is typical with many small engines). Poulan Wild Thing Replacement Chain A sharp chain is a particularly important item on any saw.

Chainsaw Poulan Wild Thing 18 Manual

Experts recommend keeping a spare one around so that you can change it in the field immediately when you need to. This also reduces the amount of time you spend running to the repair shop just to get chains sharpened. (Or do it yourself with a home ).

Ok lets get the pipes conecterd correctly to start with, the hose comeing from the tank with the filter on the end, connects to the carb fuel inlet nozzel ( the nozzel neares to the pump cover held with one screw ) the pipe coming from the other nozzel on the carb goes to the short nozzel on the primer ( suction ) then the pipe from the longest nozzel on the ptimer goes back to the tank, once you have this correct, try the saw again. Change the filter in the tank, the carb screws will have some type of anti tamper device, this is why you only have a small amount of adjustment, you may need to remove these to adjust the carb properly, if there are any splits or cracks in the fuel lines the saw will not run properly. Posted on Mar 05, 2011. This answer assumes you've put gas mix in the fuel tank.

Unless the saw is new (and possibly even if it is) there are only three things which can cause this: 1) The primer bulb is split or has a small hole in it (they rot and split often, but are not much trouble to replace) 2) The line between the bulb mount and the fuel tank is split or has fallen/been pulled off (this frequently occurs as well) 3) The fuel tank filter has trash on it and is preventing the prime. (this is harder to check and/or fix, but not impossible- and all of these are cheap!) Dec 26, 2009.

Peterbilt 379 service manual 2016. Typical Fuel System (Primer Bulb and fuel lines may not apply) Fuel Line Replacement by SmallEng.com. The hose in the tank with the filter on the free end connects directly to the carburetor input connection. If the saw is equipped with a primer bulb, an output line from the carburetor connects to the suction side of the primer (once the bulb is collapsed it draws fuel from the tank through the carburetor to refill as it inflates).

Poulan wild thing 18 chainsaw manual

Poulan Wild Thing 18 Manual

The pressure side of the primer returns displaced fuel to the tank as it is depressed. Take lots of notes and a few digital photographs to help with reassembly. The IPL (exploded parts list) for your saw is the only detail for fuel line routing and it is sketchy at best; components are listed but on multiple illustrations. Poulan.com The dash number of your serial number is the type.

Chainsaw Poulan Wild Thing Fuel Line Diagram 2375

HTH Lou Dec 23, 2009.